6
SETPOINT SETUP
6.1
Enter setpoint PIN
IF NO RELAYS ARE INSTALLED, SECTION 6 WILL BE DISABLED AND THE
NOT RESPOND TO A 3 SECOND PRESS. YOU CAN EDIT YOUR PIN NUMBER AT THE END OF
THIS SECTION (6.3). IF YOU HAVE FORGOTTEN YOUR PIN, SEE SECTION
A
Enter the setpoint setup mode by pressing the
_ _ _ ENTER SP PIN NUMBER scrolls across the display and toggles with 0. Use
the
and
P
. If the correct PIN is entered, setup is started at 6.2.
If an incorrect PIN number is entered, _ _ _ INCORRECT PIN NUMBER – ACCESS
DENIED scrolls across the display and it returns to the normal operating mode.
6.2
Edit setpoints
A
_ _ _ EDIT SETPOINT
to skip to 6.3, or use the
press
.
P
B
_ _ _ SP VALUE
value entered. Using the
selected setpoint will activate. Then press
C
_ _ _ SP ACTIVATION
setpoint activation. Using the
operate ABOVE or BELW (below) the setpoint value, and then press
ABOVE: Relay turns on above the setpoint value and off below it. BELW: Relay turns on below
the setpoint value and off above it.
Copyright © 2011
buttons to enter your security code (factory default 1). Then press
scrolls across the display and toggles with SKIP. Press
and
scrolls across the display and toggles with the last setpoint
and
scrolls across the display and toggles with the last selected
and
SETPOINT SETUP
button for 3 seconds.
buttons to select a setpoint to edit, and then
buttons, adjust the display value at which the
.
P
buttons, select the relay activation to
BUTTON WILL
8.
P
.
TEX-BAR-MAN-11V04 (SEP11)
17
P
Need help?
Do you have a question about the TEX-BAR and is the answer not in the manual?