the display value for the high level input signal. Press
The text string for [HIGH] will differ depending on your input range (selected in 5.2C): 20MA (for
0-20mA/4-20mA), 2V (for 0-2V) or 10V (for 0-10V).
H
You will be directed back to the operational display. (To enter step 5.4, you must
select SKIP at 5.3A.
SPECIFIC GRAVITY SCALE FACTOR
I
_ _ _ SPECIFIC GRAVITY
gravity scale factor. Adjust this value using the
press
P
to accept and return to the operational display.
5.4
Averaging setup
5.4 ACCESS FROM MAIN MODE
AVERAGING -
averaging, optimising stable measurement.
If the change in input exceeds the averaging
window value it will not average, ensuring fast
response when there are large differences
between readings.
A
_ _ _ AVERAGING PARAMETERS
SKIP. Press
B
_ _ _ AVE SAMPLES
selected averaging. Using the
samples that the controller will average, and then press
Increasing the number of samples will stabilise measurement, but it will also slow down response
rates.
Copyright © 2011
scrolls across and toggles with the current specific
Your controller has input signal
P
to skip to 5.5, or the
scrolls across the display and toggles with the currently
INPUT SETUP & CALIBRATION
Press
. Use
&
scrolls across the display and toggles with
button and then
and
buttons, alter the number of input
P
to accept.
and
buttons, and then
to enter PIN. Press
Input exceeds
averaging window
Averaging window
in displayed counts
Number
of samples
Sampling
P
to ENTER setup.
.
P
TEX-BAR-MAN-11V04 (SEP11)
13
3 times.
Need help?
Do you have a question about the TEX-BAR and is the answer not in the manual?