F
_ _ _ CAL LOW ANALOG OUTPUT
a calibration number. Before proceeding, connect a mA or volt meter across
the analogue output connector (see 3.5). Then use the
calibrate your low analogue output as required, and press
The display value is shown in internal units (mA or V).
G
_ _ _ CAL HIGH ANALOG OUTPUT
calibration number. Using the
output as required. Then press
The display value is shown in internal units (mA or V).
5.6
Serial setup
PLEASE SKIP THIS SECTION IF YOU DO NOT HAVE A SERIAL PORT INSTALLED. CONFIGURING
THE SERIAL PORT WILL ALLOW YOU TO CONNECT TO A PC OR ANOTHER DEVICE.
A
_ _ _ SERIAL SETUP
to skip to 5.7, or the
B
_ _ _ SERIAL MODE
selected serial mode. Using the
(custom), MDBS (Modbus/RTU) or RNGRA (Ranger A). Then press
See Appendix A for more information on serial modes.
C
_ _ _ BAUD RATE
Use the
9600, 19200 or 38400. Then press
D
_ _ _ PARITY
parity. Using the
Copyright © 2011
scrolls across the display and toggles with SKIP. Press
button and then
scrolls across the display and toggles with the currently
scrolls across the display and toggles with the current selection.
and
buttons to select one of: 300, 600, 1200, 2400, 4800,
scrolls across the display and toggles with the currently selected
and
buttons, select: NONE, ODD or EVEN. Press
INPUT SETUP & CALIBRATION
scrolls across the display and toggles with
scrolls across the display and toggles with a
and
buttons, calibrate your high analogue
P
.
to ENTER serial port setup.
P
and
buttons, choose one of: ASCII
.
P
and
buttons to
to accept.
P
P
.
P
TEX-BAR-MAN-11V04 (SEP11)
15
P
.
Need help?
Do you have a question about the TEX-BAR and is the answer not in the manual?