Define Instruments TEX-BAR Manual page 14

Process controller+bar graph
Hide thumbs Also See for TEX-BAR:
Table of Contents

Advertisement

14
INPUT SETUP & CALIBRATION
C
_ _ _ AVE WINDOW
selected averaging window value. Using the
averaging window. Then press
If your input signal contains large noise spikes, you can increase the size the of averaging
window to ensure that these are still averaged. However, increasing the window size too far will
reduce the ability of the controller to respond quickly to real changes in input signal. Setting AVE
WINDOW to 0 will give continuous averaging as per the selected averaging samples.
5.5
Analogue output setup
PLEASE SKIP THIS SECTION IF YOU DO NOT HAVE ANALOGUE OUTPUT INSTALLED.
A
_ _ _
ANALOG OUTPUT SETUP scrolls across and toggles with SKIP. Press
now to skip to 5.6, or the
B
_ _ _
LOW SCALE VALUE FOR ANALOG OUTPUT scrolls across the display and
toggles with the currently selected low scale value. Use the
enter your cal low position, and then press
This sets the display value for cal low (as at 5.5F).
C
_ _ _
HIGH SCALE VALUE FOR ANALOG OUTPUT scrolls across the display and
toggles with the currently selected high scale value. Use the
enter your cal high position, and then press
This sets the display value for cal high (as at 5.5G).
D
_ _ _ CALIBRATE ANALOG OUTPUT
P
now to skip analogue output calibration, or the
E
!
What did you select in 5.5D?
SKIP
Skip to step 5.6A
TEX-BAR-MAN-11V04 (SEP11)
scrolls across the display and toggles with the currently
.
P
button and then
? scrolls across and toggles with SKIP. Press
ENTER Continue to 5.5F
and
buttons, alter the signal
P
to ENTER analogue output setup.
P
.
P
.
button and then
P
and
buttons to
and
buttons to
P
to ENTER.
Copyright © 2011

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TEX-BAR and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents