Table of Contents
Advertisement
12
INPUT SETUP & CALIBRATION
AUTO CALIBRATION METHOD
C
_ _ _ APPLY LOW INPUT SIGNAL
across the display, and the currently selected low display value appears. Apply
the required low level input signal to the meter, and wait a moment for the signal
to stabilise. Then use the
value, and press
D
_ _ _ APPLY HIGH INPUT SIGNAL
across the display, and the currently selected high display value appears. Apply
the required high level input signal to the meter, and wait a moment for the signal
to stabilise. Then use the
value, and press
E
If
AUTO calibration was successful, you will be directed back to the operational
display. (To enter step 5.4, you must select SKIP at 5.3A.)
If calibration fails, _ _ _ CALIBRATION FAILED will scroll across the display, and
then you will be directed back to the operational display.
The most likely cause of this message is that the controller has not detected any change in input
signal during the calibration process. Check your signal and connections, and then repeat the
calibration procedure.
MANUAL CALIBRATION METHOD
F
_ _ _ ENTER DISPLAY VALUE FOR [LOW]
currently selected low display value appears. Use the
the display value for the low level input signal. Press
The text string for [LOW] will differ depending on your input range (selected in 5.2C): 0MA (for
0-20mA), 4MA (for 4-20mA) or 0V (for 0-2V/0-10V).
G
_ _ _ ENTER DISPLAY VALUE FOR [HIGH]
currently selected high display value appears. Use the
TEX-BAR-MAN-11V04 (SEP11)
– – – –ENTER LOW DISPLAY VALUE scrolls
and
P
to accept.
– – – –ENTER HIGH DISPLAY VALUE scrolls
and
buttons to set the required high level display
P
to accept.
buttons to set the required low level display
scrolls across the display, and the
P
to accept.
scrolls across the display, and the
and
buttons to set
and
buttons to set
Copyright © 2011
Advertisement
Table of Contents
Need help?
Do you have a question about the TEX-BAR and is the answer not in the manual?