Define Instruments TEX-BAR Manual page 18

18 SETPOINT SETUP
D _ _ _ SETPOINT TYPE scrolls across the display and toggles with the current
selection. Use the
and then press
ALRM -
point activation point. Hysteresis value
controls setpoint deactivation point.
Energised Above
E _ _ _ HYSTERESIS VALUE
selection. Use the
The HYSTERESIS VALUE defines the separation band between setpoint activation and
deactivation, and will operate as per the SETPOINT TYPE selected in 6.2D.
F _ _ _ MAKE DELAY
selection. Use the
a second) as required, and then press
The make delay value defines the delay between setpoint activation and when the relay turns on.
G _ _ _ OPEN ACCESS TO SP VALUE
the current direct access setting for the selected setpoint. Use the
buttons to select NO or YES, and then press
Choosing YES will allow the selected setpoint to be quick-edited via the
a PIN (see section 7). Open access can be independently configured for each setpoint.
H
!
What did you select in 6.2A?
SP 1 Skip to step 6.2J
TEX-BAR-MAN-11V04 (SEP11)
and buttons to select ALRM (alarm) or CNTRL (control),
.
P
Setpoint value controls set-
Energised Below
scrolls across the display and toggles with the current
and buttons to adjust this value if required. Press
scrolls across the display and toggles with the current
and buttons to adjust the make delay value (in tenths of
CNTRL -
Setpoint value controls set-
point deactivation point. Hysteresis value
controls setpoint reactivation point.
Energised Above
.
P
scrolls across the display and toggles with
.
P
Other Continue to step 6.2I
Energised Below
P .
and
button without entering
Copyright © 2011