Table of Contents
Advertisement
16
INPUT SETUP & CALIBRATION
E
_ _ _ SERIAL ADDRESS
selected serial address. Use the
and then press
The serial address parameter is used to identify a particular device when it is used with other
devices in a system. (It applies particularly to Modbus mode when used on an RS485 serial
network.) The serial address of the controller must be set to match the serial address defined
in the master device.
5.7
Bar graph setup
A
_ _ _ BAR GRAPH SETUP
to skip to 5.8, or the
P
B
_ _ _ LOW SCALE VALUE FOR BAR GRAPH
toggles with the current low scale bar graph setting. Use the
to enter the low scale value (in display counts), and then press
C
_ _ _ HIGH SCALE VALUE FOR BAR GRAPH
toggles with the current high scale bar graph setting. Use the
to enter the high scale value (in display counts), and then press
5.8
Edit calibration PIN
A
_ _ _ EDIT CAL PIN NUMBER
Press
P
to skip and return to the operational display, or the
P
to ENTER and change your PIN number.
B
_ _ _ ENTER NEW CAL PIN NUMBER scrolls across the display and toggles
with the current PIN (default 1). Using the
calibration PIN number. Then press
TEX-BAR-MAN-11V04 (SEP11)
scrolls across the display and toggles with the currently
.
P
scrolls across the display and toggles with SKIP. Press
button and then
scrolls across the display and toggles with SKIP.
and
buttons to alter the serial address,
to ENTER bar graph setup.
P
scrolls across the display and
scrolls across the display and
and
buttons, enter your new
P
to exit to the operational display.
and
buttons
.
P
and
buttons
P
.
button and then
Copyright © 2011
Advertisement
Table of Contents
Need help?
Do you have a question about the TEX-BAR and is the answer not in the manual?