3.7
Wire the function pins
Connect external switches as shown to enable
a function to be executed when its switch is
activated.
Valley
Clears the valley reading
Hold
Holds the current display value
Test
Resets the meter
Peak
Clears the peak reading
3.8
Wire the power supply
Determine whether your meter is configured for low or high voltage power supply.
Check the label on the unit against the colour of the connector:
•
Orange
•
Black
Then wire your power supply as shown below.
NEVER ATTEMPT
TO WIRE YOUR
CONTROLLER WHILE
THE POWER IS ON.
NEVER
CONNECT
YOUR LOW VOLTAGE
CONTROLLER TO
MAINS POWER.
Once you have completed the wiring process it is safe to switch on your power
supply. Ensure that your display is functioning before you proceed.
Copyright © 2011
= high voltage (85-265V AC, 95-370V DC)
= low voltage (15-48V AC, 10-72V DC).
High voltage
(HV)
Low voltage
(LV)
(see 3.1B)
Valley
Peak
HV power
supply
LV power
supply
WIRING
Hold
Test
COM
(see 3.1C)
+DC / live AC
-DC / neutral AC
+DC / live AC
-DC / neutral AC
TEX-BAR-MAN-11V04 (SEP11)
7
Need help?
Do you have a question about the TEX-BAR and is the answer not in the manual?