Output Meter; Output Patch - Yamaha DSP5D Editor Owner's Manual

H

Output meter

Indicates the level of the signal being output from the internal effect.
I

Output patch

Click the L CHANNEL or R CHANNEL area, and choose one of the following as the signal route that will be
patched to the L/R output channels of the internal effect.
NONE
CH 1...CH 48
STIN1L, STIN1R...STIN4L, STIN4R
FXRTN1L, FXRTN1R...FXRTN4L, FXRTN4R
INS CH1...INS CH48
INS STIN1L, INS STIN1R...INS STIN4L, INS STIN4R
INS MIX1...INS MIX24
INS MTRX1...INS MTRX8
INS STAL, INS STAR
INS STBL, INS STBR
INS MON L, INS MON R, INS MON C
If you select something other than NONE or INS MON as the insert destination, the channel name will appear in
the box located immediately below.
J
K
L
J GR meter
If "044 M.BAND DYNA", "045 M.BAND COMP" or "055 De-Esser" are selected as
the effect type, this indicates the gain reduction amount for the H (HIGH), M
(MID), and L (LOW) bands.
K SOLO
If "044 M.BAND DYNA" or "045 M.BAND COMP" are selected as the effect type,
these buttons allow you to monitor only the specified band from the three bands
HIGH, MID, and LOW.
L
Equalizer
If "053 EQUALIZER601" is selected as the effect type, the FLAT button which sets
the EQ values to a flat state and the DRIVE button and CLEAN button which specify
the EQ type will become active.
Not inserted
Input channel 1–48 input
ST IN channel 1–4 (L/R) input
FX RTN channel 1–4 (L/R) input
Input channel 1–48 insert in
ST IN channel 1–4 (L/R) insert in
MIX channel 1–24 insert in
MATRIX channel 1–8 insert in
STEREO A channel (L/R) insert in
STEREO B channel (L/R) insert in
MONITOR channel (L/R/C) insert in
52 PM5DV2/DSP5D Editor Owner's Manual