Cue/Solo Window - Yamaha DSP5D Editor Owner's Manual

Pm5dv2 / dsp5d editor owner's manual

Hide thumbs Also See for DSP5D Editor:

Table of Contents

Cue/Solo window

In this window of the editor you can edit and view the cue and solo status of the PM5D/DSP5D.

Choose [Windows] → [Monitor] → [Cue/Solo] to access this window.

SOLO ON/OFF

This button selects either CUE MODE or SOLO mode as the monitoring method when the [CUE] key is used. If

you turn this button on, a conﬁrmation message will appear. Each mode operates as follows.

• CUE mode (SOLO ON/OFF button is off)

The signal of the channel whose [CUE] key is pressed will be sent to the dedicated CUE bus, and monitored

via the CUE bus from the CUE OUT jacks. This mode allows you to monitor the signal of the desired channel

without affecting other buses.

• SOLO mode (SOLO ON/OFF button is on)

If you solo an input, the Solo function will be enabled, and only the signal of the channel whose [CUE] key is

pressed will be sent to the MIX, MATRIX, and STEREO A/B buses; the other channels will be muted. If you

solo an output, only that channel will be on. The signal of the channel whose [CUE] key is pressed can also be

monitored via the CUE OUT jacks.

CUE MODE

This button selects one of the following two modes of operation for when the [CUE] key of more than one chan-

nel is pressed. If it is off, operation will be in MIX CUE mode.

• MIX CUE mode

You can monitor the more than one channels or DCA groups whose [CUE] keys are turned on within the

same CUE group.

• You cannot simultaneously turn on [CUE] keys of differing groups. The CUE group to which the last-

NOTE

pressed [CUE] key belongs will be on, and signals of that CUE group can be monitored.

• If you press the [CUE] key of a paired channel, both channels will be on.

PM5DV2/DSP5D Editor Owner's Manual

Table of Contents

Pm5dv2 editor