Meter Window; Effect Parameter Section; Mix Balance Control - Yamaha 02R96 Version 2 Owner's Manual

F

Effect parameter section

This section contains the various effects controls, buttons, and displays. Its layout depends on the
selected effect type.
G
[MIX BALANCE] control
This control enables you to adjust the balance between the wet and dry signals. When set to 0, only the
dry signal is heard. When set to 100, only the wet signal is heard.
H
[BYPASS] button
This button is used to bypass the currently selected effects processor.

Meter Window

The Meter window displays the Input, Output, Effect, and Stereo Out meters. To open the Meter win-
dow, choose [Meter] from the [Windows] menu. This window consists of four display pages. You can
access these pages by clicking the tabs along the top of the window.
Page
CH1-56 page
MASTER page
Effects 1-4 page
Stereo page
The layout of the Meter window pages is the same regardless of the page selected. (The Master page is
shown below.)
A Meter mode
You can select the type of meters to be displayed from the following options:
GATE GR:
COMP GR: The meters indicate the amount of gain reduction being applied by the channel
LEVEL:
B
POSITION parameter
This parameter, available only when Meter mode is set to Level, enables you to select the metering
position in the signal path.
C
PEAK HOLD button
This button turns the Peak Hold function on and off.
This page displays the Input Channel CH1-56 meters (12 segments).
This page displays the Bus 1-8, Aux 1-8, and Stereo meters (12 segments).
This page displays the Channel 1 & 2 input/output meters (12 segments) for Effects
1-4.
This page displays a bar graph (32 segments) of signal levels output to the Stereo Out.
A
The meters indicate the amount of gain reduction being applied by the channel Gate.
Compressor.
The meters indicate the channel level.
Studio Manager for V2 02R96 Editor—Owner's Manual
Function
2 3
28