Yamaha DSP5D Editor Owner's Manual page 26

M COMP LINK GROUP (Compressor link group)
Selects the compressor link group (1–8) to which that channel belongs.
N KEY IN
Selects the signal that will be used as the key-in signal. The types of signal that can be selected are the same as for
the gate key-in signal (➥ p.24).
❏ INSERT (except for FX RTN channels)
A HA GAIN (head amp gain) and +48V
Here you can adjust the HA gain for the input (if it has HA) that is patched to INSERT IN, and turn +48V on/off.
B ON (On/off)
Enables/disables insert-in/out.
C OUT (Insert out)
Here you can select the output port that will be assigned to insert-out, from the following choices.
NONE
MIXOUT1...MIXOUT24
OMNIOUT1...OMNIOUT24
S1-1, S1-2...S4-15, S4-16
FX1L, FX1R...FX8L, FX8R
GEQIN1...GEQIN20
2TR D1L, 2TR D1R...2TR D3L, 2TR D3R
D IN (Insert in)
Here you can select the input port that will be assigned to insert-in, from the following choices.
NONE
AD1–AD48
AD1L, AD1R...AD4L, AD4R
S1-1, S1-2...S4-15, S4-16
FX1L, FX1R...FX8L, FX8R
GEQOUT 1–20
2TR D1L, 2TR D1R...2TR D3L, 2TR D3R
2TR A1L, 2TR A1R, 2TR A2L, 2TR A2R
E POINT (Insert point)
Selects the position at which insert-in/out will be patched. Choose from Pre EQ, Post EQ, Pre Delay, or Post
Fader.
1 2
No assignment
The channels of MIX OUT jacks 1–24
This cannot be selected on the DSP5D
The channels of OMNI OUT jacks 1–24
This cannot be selected on the DSP5D
Output channels of an I/O card installed in slots 1–4
L/R inputs of internal effects 1–8
Inputs of GEQ modules 1–20
L/R channels of 2TR OUT DIGITAL jacks 1–3
This cannot be selected on the DSP5D
No assignment
INPUT jacks 1–48
The L/R channels of ST IN jacks 1–4.
Input channels of an I/O card installed in slots 1–4
L/R outputs of internal effects 1–8
Outputs of GEQ modules 1–20
L/R channels of 2TR IN DIGITAL jacks 1–3
This cannot be selected on the DSP5D
L/R channels of 2TR IN ANALOG jacks 1/2
This cannot be selected on the DSP5D
26
3
4
5
PM5DV2/DSP5D Editor Owner's Manual