SEVERIN FW 3782 Instructions For Use Manual page 10

●
Always switch the appliance off and
remove the plug from the wall socket
- in case of any malfunction,
- after use,
- during cleaning,
- when changing attachments.
●
When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
●
No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
●
This appliance is intended for domestic
use only and not for commercial
applications.
●
In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The addresses can be found in the
appendix to this manual.
Before using for the first time
Remove any
completely.
Before the appliance is used for the first
time, all attachments and accessories should
be cleaned as described in the section
General Cleaning and Care.
Control switches
On/Off switch
This On/Off switch is used to turn the
appliance on and off.
Reverse button
This reverse button (R) allows for
temporary reverse action of the worm drive.
Turn the appliance off and keep the reverse
button pressed.
If the button is pressed during normal
operation, the worm drive will stop.
Speed selector switch
The speed selector switch allows for high or
packaging materials
low speed selection.
This button may be pressed before the
appliance is switched on, or during
operation.
Operation
General information
●
Always fit the required attachment
before use.
●
Always switch the appliance off after use,
and wait until the motor has come to a
complete standstill. Remove the plug
from the wall socket before any
attachments are added or removed.
Worm-drive housing
The worm-drive housing is fitted as follows:
Insert the worm-drive housing into the main
unit while ensuring that the recess is
correctly aligned. Initially, the feeder chute
should be turned slightly clockwise, before it
is turned anti-clockwise into a vertical
position.
The worm-drive housing is properly fitted
and safely locked only if the feeder chute is
facing upwards and the locking button is
heard clicking into place.
To remove the worm-drive housing, turn it
clockwise while keeping the button
depressed.
A. Mincing meat
- Slide the worm drive into its housing
drive-wheel first.
- When fitting the 4-bladed knife to the
square end of the worm drive, ensure
that the blade area is still visible.
- Fit the required perforated disc in front
of the blade assembly, ensuring that the
protruding lug in the drive housing is
correctly aligned with the corresponding
recess on the insert.
- For pies, mince or smaller sausages
such as frankfurters or chipolatas, the
fine disc should be used.
- The medium disc is suitable for such
10