Surface Mounting - HMS Networks Anybus Wireless Bridge II CAN AWB3006 Startup Manual

Surface Mounting

4.2. Surface Mounting
Bridge II CAN can be screw-mounted directly onto a flat surface.
Before You Begin
NOTE
To avoid signal interference, a minimum distance of 50 cm between the
devices should be observed. See also
Procedure
Figure 3. Surface mounting holes
• To screw-mount the Bridge II CAN on a surface, use the two holes (Ø 4 mm) at the
corners of the Bridge II CAN.
SP2965 1.4
®
Anybus
Wireless Technology
™
Wireless Bridge II CAN
Basics.
Page 9 of 28