Recovery Mode - HMS Networks Anybus Wireless Bridge II CAN AWB3006 Startup Manual

Recovery Mode

5.7. Recovery Mode
If the built-in web interface cannot be accessed, the unit can be reset by starting in
Recovery Mode and reinstalling the firmware.
Before You Begin
IMPORTANT
Use Recovery Mode only when the unit is unresponsive and the built-in
web interface cannot be accessed. Firmware updates should normally be
carried out through the built-in web interface.
Procedure
To enter Recovery Mode
1. Press and hold MODE button during startup.
Figure 8. MODE button
2. Bridge II CAN enters Recovery Mode.
Table 4. In Recovery Mode the Status LEDs indicate the firmware update status
LED
PWR
WLAN + BT
SP2965 1.4
Indication
Green
Green, blinking
Alternating red/blue
Anybus
Description
Firmware update in progress
Waiting for valid firmware
Firmware update in progress
®
Wireless Bridge II CAN
Page 21 of 28
™