Important Instructions - Modern Flames LPS-4414V2/INT Installation Manual

IMPORTANT INSTRUCTIONS

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire,
electric shock, and injury to persons, including the following:
1. Read all Instructions before installing or using the heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible
materials, such as furniture, pillows, bedding, papers, clothes, etc. and curtains at least 3 feet (0.9 m)
from the front of the heater and keep them away from the sides and rear (sides and rear restrictions
apply to location dedicated heaters only)
3. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the
heater is left operating and unattended.
4. Do not operate heater after it malfunctions. Disconnect power at service panel and have the heater
inspected by a reputable electrician before reusing.
5. To disconnect heater, turn controls to off, and turn power to heater circuit at main disconnect panel (or
operate internal disconnect switch if provided).
6. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the heater.
7. To prevent a possible fire, do not block air intakes or exhaust in any manner.
8. A heater has hot and arcing or sparking parts inside. Do not use if in areas where gasoline, paint, or
flammable vapors or liquids are used or stored.
9. Use this heater only as described in this manual. Any other use not recommended by the manufacturer
may cause fire, electric shock, or injury to persons.
10. This heater may include an audible or visual alarm to warn that parts of the heater are getting
excessively hot. If the alarm sounds (or illuminates), immediately turn the heater off and inspect for any
objects on or adjacent to the heater that may have blocked the airflow or otherwise caused high
temperature to have occurred. DO NOT OPERATE THE HEATER WITH THE ALARM SOUNDING (OR
ILLUMINATING).
"SAVE THESE INSTRUCTIONS"
12.
• Use a dedicated circuit breaker of 13 A (EU) or A (AU/NZ) (or more).
• Never use with an extension cord or relocatable power tap (outlet/power strip).
• Never use a wall mount bracket from another manufacturer.
• Always disconnect this unit from the power supply before performing any assembly or cleaning, or
before relocating the electric fireplace.
• Always store this heater in a dry location. Never use the fireplace if it has become wet.
• This product is not intended to be a primary heat source. It is for supplemental heat only.
ATTENTION
Additional Important Instructions
2