Taurus cardiostrong EX90 Touch Assembly And Operating Instructions Manual page 22

Step 13: Alignment of the feet
If the floor is uneven, you can stabilize the equipment
by turning the two setting screws under the main
frame.
1. Lift the equipment on the desired side and
rotate the setting screws under the main frame.
2. Rotate the screws clockwise in order to remove
them and to raise the equipment.
3. Rotate them counterclockwise in order to lower
the equipment.
Step 14: Connecting the equipment to the mains supply
࣑ ATTENTION
The equipment must not be connected to a multiple socket, otherwise it cannot be guaranteed
that the equipment will be supplied with sufficient power. Technical errors can result.
1. Plug the cable into the socket on the main frame.
2. Plug the power plug into a wall outlet that complies with the instructions in the chapter on
electrical safety.
NOTICE
L
The overload switch protects from short circuits. The button jumps out in case of overload. Turn
the power switch off and then on again to restart the equipment
22
EX90 Touch