cytiva AKTA process Unpacking Instructions Manual page 27

Step
7
8
9
ÄKTA process Unpacking Instructions 29605009 AD
Action
Remove the foam blocks from the top of the pump.
Prepare the ramp:
a. Place the two ramp supports on the floor on the ramp side of the crate.
b. Attach the ramp panel to the ramp side of the crate and align the ramp
supports with the guides provided on the ramp panel.
Note:
Make sure the metal rim of the ramp panel is set in the groove of the
bottom panel of the crate.
c. Fold down the ramp panel until it rests on the ramp supports.
d. Check that the ramp is steady.
Remove one of the side panels (tilt the panel outwards approximately 20
degrees to release the panel from the supporting rail).
27