Troubleshooting - Omron Z5FP-MC10 Setup Manual

SECTION 4
Appendix

Troubleshooting

This section provides information on hardware errors and temporary remedies to be taken. Refer to this
section before requesting service from your OMRON representative.
Connection Errors
Problem
The Power indicator
does not light up.
The video monitor is
blank.
The video monitor image
is not clear.
Cannot make key inputs
from the console.
No image is displayed.
Sensor Errors
Problem
The measurement range
is different from that of
the sensor specification.
42
Setup Manual
Probable cause
The power supply is not connected properly.
The 24 V DC (21.6 to 26.4 V DC) supply voltage has dropped.
The power supply to the video monitor is not turned on.
The monitor cable is not connected properly.
The video monitor is malfunctioning.
(In the case of a liquid crystal display monitor)
The capacity of the power supply is insufficient.
There is electric noise entering from the power supply or cables.
The monitor cable is not connected properly.
The console cable is not connected correctly.
The sensor cable is not connected correctly.
There is no workpiece inside the measurement range.
The sensor is not mounted in the correct position.
Probable cause
When you replaced the sensor connected to the controller, did
you turn off the download function?
Reference
p.19
p.16
-
p.16
p.16
p.25
Reference
(Operation)
p.179