Table of Contents
Advertisement
Refer to the separate volume, Operation Manual, for the role of each terminal.
•
Do not reverse the connections of the signal terminals and COM terminals.
•
RESET Terminal
Do not input the RESET signal immediately after turning the power supply on. When using the
RESET signal to synchronize the startup timing, wait at least 1 second after turning the Controller's
power supply on before turning the RESET terminal on.
The initial status of the output terminals is off. The terminals may turn on for approximately 0.5
seconds when the power supply is turned on, however. Make sure that these outputs are not treated
as actual signals by external devices.
SECTION 3
Connecting External Devices
Setup Manual
33
Advertisement
Table of Contents
