Replay Using The I/O Condition Tool - Omron WS02-SIMC1-E - V1.9 REV 02-2009 Operation Manual

Running by Virtual External Inputs
Pausing the Data Replay Tool Clicking the [Pause] button in the [Run] window will pause the data replay.
Getting monitor data using
the Data Replay Tool

8-4-3 Replay Using the I/O Condition Tool

180
Also, the following conditions of the Ladder Engine will pause the replay.
Conditions of the
Ladder Engine
Program/Run mode
Break on Break Points Synchronous
Break on I/O Break
Condition
Note Keep the Ladder Engine in Scan Run Status while synchronizing the Data
Replay Tool. If Continuous Run (Monitor Mode) or Continuous Scan Run is
used, synchronism in the unit of a scan will be lost. When the program has
been interrupted on a break point, etc., resume it with Scan Run.
Note While executing asynchronously, the data will be replayed even while the
Ladder Engine is not executing a ladder program.
The Data Replay Tool can save only the monitor data of the specified I/O
memory areas to the output file regardless of the Replay File. When outputting
only the monitor data, specify only an output file (and the template file as
required), not the Replay File.
The I/O Condition Tool specifies the execution file of the I/O Condition ex-
pressions specified in the [Settings] window in advance and monitors the
changes of the I/O memory areas set by the condition expressions of the I/O
Condition expressions, outputting when the conditions hold.
CX-Programmer
The I/O Condition Tool operates independently of the Debugger.
Synchronous/Asynchronous
Synchronous/Asynchronous
Synchronous
Computer
Debugger
FinsGateway
Virtual Communications Unit
CPU Simulator
Unit Communi-
cations Unit
Section 8-4
How to clear
Scan Run for Synchronous
and Continuous Run (Monitor
mode) for Asynchronous.
Scan Run
Scan Run
I/O Condition Tool