Omron WS02-SIMC1-E - V1.9 REV 02-2009 Operation Manual page 12

NSJ Series
Models
NSJ@-TQ@@(B)-G5D
NSJ@-TQ@@(B)-M3D
Function Support by Unit Version
• Functions Supported for Unit Version 4.0 or Later
CS1-H CPU Units
Online editing of function blocks
Note: This function cannot be used for simulations on the
CX-Simulator.
Input-output variables in function blocks
Text strings in function blocks
New application Number-Text String Conversion Instructions:
instructions NUM4, NUM8, NUM16, STR4, STR8, and STR16
TEXT FILE WRITE (TWRIT)
Using ST language programming in tasks
Using SFC programming in tasks
CS1D CPU Units
xiv
Unit version 3.0
The following tables show the functions supported by the CX-Programmer and
CX-Simulator depending on the unit version of the CPU Unit. Refer to 1-1-4
Summary of CX-Simulator Functions (Comparisons with Actual PLC) and 1-6
Comparison of CX-Simulator and SYSMAC CS/CJ-series PLCs for compari-
sons between CX-Simulator functions and the actual PLC.
The functions supported for CJ2 CPU Units with unit version 1.0 correspond to
those for CS/CJ Units with unit version 4.0 or later.
The following tables list the functions added for unit version 4.0 and supported
by the CX-Programmer. CX-Programmer version 7.0 or higher and
CX-Simulator version 1.7 or higher are required to use these functions.
Additional functions are supported if CX-Programmer version 7.2 or higher is
used.
Function
Unit version 4.0 is not supported.
Unit versions
Unit version 4.0 or
OK
OK
OK
OK
OK
OK with CX-
Programmer Ver. 7.2 or
higher
OK with CX-
Programmer Ver. 7.2 or
higher
CS1@-CPU@@H
Other unit versions
later
---
---
---
---
---
---
---