Settings - Omron WD30-ME Operation Manual

DeviceNet Wireless Slave Station Specifications
4-2-2

Settings

NNODE switch (DeviceNet
node address setting
switch)
DeviceNet setting switch
(SW1)
Maintaining/
Clearing output
when there is a
DeviceNet slave
communication
error
64
Set the DeviceNet interface node address here. Set the switches before turn-
ing on the power supply. Only the setting values detected immediately after
the power supply has been turned on are enabled. Changes to switch settings
after the power supply has been turned on are ignored.
N NODE
X10 X1
Set the DeviceNet interface communication speed, relay station, and mea-
sures for when communication errors occur.
"Maintain/Clear output when communication errors occur" is for setting
whether to maintain or clear the ON output when a wireless network error
occurs and while communication continues in the DeviceNet network that the
wireless slave station is connected to. (Although communication continues in
the wireless network when an error occurs in the DeviceNet network, the ON
input to the wireless master station at that time becomes "Maintain".)
Set the switches before turning on the power supply. Only the setting values
detected immediately after the power supply has been turned on are enabled.
Changes to switch settings after the power supply has been turned on are
ignored.
SW1
ON
1 2 3 4
No. Contents
1 Communication
speed selection
2
3 Relay station/No relay station
selection
4 Maintain/Clear output when
communication errors occur
• DeviceNet communication rate settings
Baud rate DIP-SW status
1
MODE1
125k OFF
250k ON
500k OFF
- ON
Applications that require the maintaining of output when a DeviceNet slave communication error
occurs (if ON must be maintained when an error is occurred) cannot be used.
MODE1
MODE2
Remarks
2
MODE2
OFF Length of main line: 500m
OFF Length of main line: 250m
ON Length of main line: 100m
ON Settings prohibited, no
communication
Section 4-2