Omron WD30-ME Operation Manual page 86

Installation Test
Master station
MS NS WS
N NODE
RUN
TEST
X10 X1
SET
SW1
ON
1 2 3 4
74
Slave station
MS NS
SW2 N NODE
X10 X1
SW1
ON
1 2 3 4
Master station
SW2
RUN
TEST
SET
WS
SW2
RUN
TEST
SET
5. Set the WNODE switch of the wire-
W NODE
X10 X1
W CH
X10 X1
SW3
ON
1 2 3 4 5 6 7 8
Section 5-2
If the WS LED lights green, this
means that the wireless communi-
cation link has been established.
Position the devices so that the WS
LED lights green. If the electric wave
is weak, adjust the position of the
wireless slave station so that receiv-
ing wave level is stabilized in L5 or
higher.
The LED display shows the
receiving wave level "L0" if the
devices have been installed
outside the distance where
they cannot receive the
electric wave from each other.
less master station to the WNODE
number ("00" for this example) of the
wireless slave station to be tested
next, and then press SW2.
Repeat this procedure till the com-
munication with all wireless slave
stations is established and stabi-
lized.