ETC ColorSource PAR jr Installation Manual page 6

ETC Installation Guide
ColorSource PAR jr
DMX Control Channels
5ch
DMX
Channel
(5 channel)
1 Intensity
2 Red
3 Green
4 Blue
5 Strobe**
6
*Original ColorSource PAR jr fixture uses blue in channel 4; Deep Blue fixture uses indigo in
channel 4.
**Use DMX values of 0 or 255 for no strobe. Use values of 1–254 to increase the strobe rate
from 1 per second up to 33 per second.
Data Loss Behavior
When DMX data is lost, the fixture does one of the following actions:
• If you selected a preset or sequence, that preset or sequence
automatically plays.
• If no preset or sequence is active in the background, the fixture
goes dark and the DMX start address flashes on the user interface.
Lock the User Interface
After you have set up the fixture, you can lock the user interface to pre-
vent additional changes.
1. Press and hold the Up button and Down button simultaneously for
3 seconds. The display will show
interface is locked.
2. To unlock the user interface, press and hold the Up button and
Down button simultaneously for 3 seconds.
ColorSource PAR jr
dir
(Direct)
Intensity
Red
Green
Blue/Indigo*
Lime
Strobe**
Loc
Page 6 of 12
1ch rgb
(1 Channel) (RGB)
Intensity Red
Green
Blue
to indicate that the user
ETC