Omron NS Manual page 355

Appendices
NS-Designer Operation Manual
Downloading aborted. This Project includes
the file which name contains invalid charac-
ter. The characters that can be used are
alphanumeric characters (0 to 9, A to Z, a
to z), dollar sign ($), underscore (_), and.
Check and adjust project file.
End address is not set.
End page No. is out of range. Set a number
from 0 to 3999.
End page No. is smaller than the start page
No.
End sheet number is out of range. Set a
number from 0 to 9.
Error detected at NS hardware. (0x03a7)
Error occurred while writing to a flash
memory. Transmission failed.
Exceeding maximum/minimum limit.
Failed to create new folder.
Failed to delete.
Failed to export CSV file.
Failed to get configuration information from
the printer for NS-Designer. Settings can-
not be performed for the printer.
Failed to import CSV file.
Failed to open communications with the
PLC. CX-Server reported an unknown er-
ror.
Failed to read file.
(Data Block (X) CSV File)
Failed to read project file.
Failed to register.
Failed to restore the project.
Failed to save file.
Message Countermeasure
There are limits on transferable file names. Check the
error message and use NS-Designer to adjust the file
name accordingly. There are similar limits on notation
for text files indirectly accessed.
Correctly designate the end address for replacement in
the Replace Dialog Box.
The end page number is 3,999. Set the end page
number to a number between 0 and 3,999.
Set the start page number so that it is smaller than the
end page number.
Sheet screen page numbers must be set in the range 0
to 9.
Set the sheet screen page number to a number be-
tween 0 and 9.
Contact your OMRON service representative.
Initialize data using Screen data region format on the
Data Initialization Tab Page under System Menu and
transfer the project.
Set a number within the upper and lower limits.
The folder could not be created because of insufficient
space on the hard disk.
Increase the available space on the hard disk and re-
peat the operation.
Check to see if the specified category or file has been
opened by another application and repeat the opera-
tion. It is also possible that data has been corrupted.
The file could not be saved because of insufficient
space on the hard disk. Increase the available space
on the hard disk and repeat the operation.
This message is displayed when files containing infor-
mation for printer settings cannot be obtained. Reinstall
NS-Designer.
Check to be sure that the file to be imported is in CSV
format and repeat the operation.
Exit Screen Data Transfer of NS-Designer if this mes-
sage appears on the CX-Server when connecting to
the PLC to send the settings for the Path Through
PLC.
The specified CSV data file does not exist. Create a
CSV data file in the project folder.
The project file may be corrupted. If there is a backup
file, restore the project file using the backup file under
Project Maintenance - File - Project Maintenance.
Check to see if the specified category in the library has
been opened by another application and repeat the
operation. It is also possible that data has been cor-
rupted.
Not have any free space left.
Change the Restore Destination or increase the free
space, and repeat the operation.
The file could not be created because of insufficient
space on the hard disk. Increase the available space on
the hard disk and repeat the operation.
A-21
Appendix 6 Error Messages