Omron NS Manual page 241

Section 10 Transferring Data
NS-Designer Operation Manual
Preparations for Transferring Data via Modems
To transfer data, connect the PT and the computer running NS-Designer via cables and modems. Refer
to the operation manual for the modem for modem settings.
Settings before Transferring Data via Modems
Make the following settings when connecting the computer to a modem and transferring data over
telephone lines to a PT connected via a modem.
PT Settings
The baud rate must be set before transferring screen data to a PT connected via modems. Set the se-
rial port to be used to a modem connection on the System Menu – Comm. Tab Page, click the Details
Button and set the following items.
Item
Baud rate
Data bits
Stop bits
Parity
System Configuration Example
Serial
NS-Designer
R e f e r e n c e
R e f e r e n c e
Reference
♦ When using a project created with system version 5.X or lower, select Settings - Conversion -
Project -to Ver. 6.0 from the NS-Designer and convert to system project version 6 before making
the settings.
Set the baud rate between the modem and PT to 9600, 19200, 38400, 57600,
or 115200.
The number of data bits (length) is always 8 bits.
The number of stop bits (length) is always 1 bit.
The parity bit setting is always None.
Phone line
Modem
Setting
Serial
Modem
PT
10-5
10-1 Transferring Data to the PT