Adjust The Volume - CyberData VoIP Intercom Operation Manual
Cyberdata voip intercom operations guide
Hide thumbs
Also See for VoIP Intercom:
- Specification sheet (2 pages) ,
- Installation quick reference (2 pages)
Table of Contents
Advertisement
To announce an Intercom's current IP address:
1. Install the RTFM jumper.
2. After two seconds, the IP address will be announced.
Note
2.2.7 Adjust the Volume
You will be only able to adjust the volume through the network configuration page.
Operations Guide
Figure 2-12. RTFM Switch Jumper
If you installed the RTFM jumper, and if you press the call button for 10 seconds, the default
factory settings will be initiated.
930181B
Installing the VoIP Intercom
Intercom Setup
CyberData Corporation
15
Advertisement
Table of Contents
Need help?
Do you have a question about the VoIP Intercom and is the answer not in the manual?
Questions and answers