Restoring The Factory Default Settings; Restore The Factory Default Settings - CyberData VoIP Intercom Operation Manual

14 Installing the VoIP Intercom
Intercom Setup

2.2.6.2 Restoring the Factory Default Settings

To restore the factory default settings:

2.2.6.3 Restore the Factory Default Settings

When troubleshooting configuration problems, it is sometimes convenient to restore the device to a
known state.
Each Intercom is delivered with factory set default values for the parameters indicated in
Use the RTFM switch on the Intercom face to restore these parameters to the factory default settings.
Note
Parameter
IP Addressing
IP Address
Web Access Username
Web Access Password
Subnet Mask
To restore these parameters to the factory default settings:
CyberData Corporation
1. Complete the steps in
2. Press and hold the Call button for 10 seconds.
3. When you hear the announcement, release the Call button. The factory default settings are
restored, and the intercom will automatically restart.
When you use the RTFM switch, the factory default settings are restored for only the
parameters indicated in
configuration will remain unchanged.
Section 2.2.6.1, "Announcing the IP
Table 2-3. The other parameters in the current Intercom
Table 2-3. Factory Default Settings
930181B
Address".
Factory Default Setting
static
192.168.3.10
admin
admin
255.255.255.0
Table 2-3.
Operations Guide