Installation Of Configuration Software - Omron GRT1-PNT Operation Manual

Installation of Configuration Software

2-6

Installation of Configuration Software

2-6-1 Installation requirements
2-6-2 Installation procedure
DTM Installation
38
In order to operate the GRT1-PNT and the SmartSlice I/O system the
PROFINET IO Controller needs to be configured for communication with the
GRT1-PNT. For this purpose OMRON provides the GRT1-PNT DTM via the
OMRON web site http://www.omron-industrial.com/
After installation the DTM will run in the FDT Container, allowing the user to
set up the I/O configuration and set the parameters of the GRT1-PNT and of
the individual SmartSlice I/O Units.
The following are the minimum requirements for a PC to install the GRT1-PNT
DTM configuration software:
• PC Pentium III or higher, 500 MHz minimum
• Operating System: Windows 2000 SP2 or Windows XP
• RAM: 256 MB minimum
• Hard disk space: 256 MB minimum
• Graphics resolution: 1024 x 768 pixels minimum
• Installed FDT Container software, e.g. OMRON's CX-ConfiguratorFDT.
This section explains how to install the SmartSlice I/O Coupler DTM software.
1,2,3... 1 Exit all other Windows-based programs.
2 Double-click the file SmartSlice_IO_Coupler_Setup.exe.
The setup program for the GRT1-PNT DTM will start.
Select the preferred Language for the Setup and click OK.
3 The user is then guided through the installation process.
Section 2-6