Table of Contents
Advertisement
Turn on the Flashforge Creator Max again and connect your computer to the network. Open
FlashPrint, then click Print > Connect Machine. Select Wi-Fi as the Connect Mode and enter
the IP Address, as shown on the Flashforge Creator Max's screen. Click Connect.
If you want to switch between AP and STA modes, touch the Reset button on the WIFI Screen.
Updating the Firmware
Each time you start FlashPrint, it will automatically detects and downloads the up-to-date
firmware. If an update is available, a dialog box will appear to remind you of the update.
Perform the following steps to update the firmware.
1. Click Tools > Update firmware. You must sever any existing connection with the printer before
updating. If a connection exists, it will prompt you to cut the connection. Click the Yes button to
cut the connection.
2. Choose the corresponding printer type and firmware version, then click OK in the firmware
update dialog. After confirming that there is no printer connection, the software will
automatically update the firmware.
41
Advertisement
Table of Contents
Need help?
Do you have a question about the Creator Max and is the answer not in the manual?
Questions and answers