FLASHFORGE 3D PRINTER Creator Max User Manual page 40

AP mode configures the printer's Wi-Fi® radio to act as a Wi-Fi Hotspot/Access Point (AP).
You then set your computer's network settings to directly connect to the printer's Wi-Fi AP, rather
than your regular Wi-Fi AP.STA mode configures the printer's Wi-Fi® radio to connect to your
regular Wi-Fi AP. In STA mode you do not need to change your computer's network settings and can
continue to use your Wi-Fi AP, as normal.
If you choose to use AP mode, you can set the network name (Flashforge Creator Max) and password
of the hotspot. If you don't want to use a password, enter NONE. Click the Save button and restart it.
Connect your PC to the network (the name you set). Open FlashPrint, then click
Print > Connect Machine. Select Wi-Fi as the Connect Mode and enter the IP Address, as shown on
the Flashforge Creator Max's screen. Click Connect.
Sys status
WiFi Set
Trans Set
Reload Reset
About FF
WiFi Mode Select
Wifi Work Mode
AP mode
Network Name(SSID) (1-32 bytes)
Password(8-63 bytes), NONE is Open
IP address
Mask
STA mode
Router SSID(Note: case sensitive)
STA Password, Set NONE is Open
DHCP auto get IP
Flashforge Creator Max
39
AP mode
NONE
10.10.100.254
255.255.255.0
Save
USR-C322
NONE
Enable
Save