Table of Contents
Advertisement
Wi-Fi Connection
Perform the following steps to connect your PC to the printer using a Wi-Fi® connection.
Note that printing from an SD™ card is disabled when Wi-Fi is enabled.
1. Power on the printer and your computer.
2. On the printer, select Tool > Setting > WIFI > WIFI ON.
3. Open your computer's wireless network settings and scan for available Wi-Fi® signals.
4. Open your internet browser. Type 10.10.100.254 and press the Enter key on your keyboard.
Enter the username and password to login. The default username and password are both admin.
The control panel will appear after successful login.
5. Click the WiFi Set tab on the left, then set the WiFi Work Mode to AP mode or STA mode, then click
Restart to make the changes take effect.
Sys status
WiFi Set
Trans Set
Reload Reset
About FF
Sys status
Sys run time
module MAC
module MID
module ver
wifi Status
wifi mode
AP IP
AP channel
AP ssid
AP secure
38
0 days 00:09:06
D8:B0:4C:D0:38:4E
USR-C322
1.14.13
Access Point
10.10.100.254
6
Flashforge Creator Max
3DPrinter
Open
Advertisement
Table of Contents
Need help?
Do you have a question about the Creator Max and is the answer not in the manual?
Questions and answers