Safety Warnings And Guidelines - FLASHFORGE 3D PRINTER Creator Max User Manual

Safety Warnings & Guidelines
Please read this entire manual before using this device, paying extra attention to these safety
warnings and guidelines. Please keep this manual in a safe place for future reference.
· Take care to avoid touching hot parts, including heat blocks, extruder nozzles, build plate,
and the extruded filament.
· Do not wear gloves when operating or repairing to avoid entanglement.
· Keep the printer and all accessories out of reach of children.
· Do not remove or disconnect the USB cable when printing from a computer.
· Do not force or tear anything during unpacking and setup. This may cause damage to the
printer and/or its accessories.
· Do not reach inside the printer during operation.
· Always allow the printer and extruded filament to cool before reaching inside.
· Ensure that the printer is turned off and unplugged from its power source before making
repairs or performing service.
· Do not install this device on an unstable surface where it could fall and cause either personal
injury or damage to the device and/or other equipment.
· Do not subject the product to extreme force, shock, or fluctuations in temperature or humidity.
· This device is intended for indoor use only.
· Do not expose this device to water or moisture of any kind. Do not place drinks or other
containers with moisture on or near the device. If moisture does get in or on the device,
immediately unplug it from the power outlet and allow it to fully dry before reapplying power.
· Do not touch the device, the power cord, or any other connected cables with wet hands.
· Use only in a well-ventilated area. Do not use in close, confined spaces.
· Prior to operation, check the unit and power cord for physical damage. Do not use if physical
damage has occurred.
· Before plugging the unit into a power outlet, ensure that the outlet provides the same type and
level of power required by the device.
· Unplug this device from the power source when not in use.
· Take care to prevent damage to the power cord. Do not allow it to become crimped, pinched,
walked on, or become tangled with other cords. Ensure that the power cord does not present a
tripping hazard.
· Never unplug the unit by pulling on the power cord. Always grasp the connector head or adapter
body.
02