FLASHFORGE 3D PRINTER Creator Max User Manual page 41

If you choose you use STA mode, input the SSID and password of your existing Wi-Fi® connection.
If your Wi-Fi connection does not use a password, enter NONE into the password field. Then click
the Save button and restart it. Restart the Flashforge Creator Max printer, then open the WIFI Screen.
Sys status
WiFi Set
Trans Set
Reload Reset
About FF
WiFi Mode Select
Wifi Work Mode
AP mode
Network Name(SSID) (1-32 bytes)
Password(8-63 bytes), NONE is Open
IP address
Mask
STA mode
Router SSID(Note: case sensitive)
STA Password, Set NONE is Open
DHCP auto get IP
SSID: Market Department
Signal Strength: 100
IP Address: 192.168.1.119:8899
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.1
Reset WIFI off
40
STA mode
Flashforge Creator Max
NONE
10.10.100.254
255.255.255.0
Save
Market DP.
NONE
Enable
Save