Omron E5ZE Operation Manual page 21

Setting Selectors and Switch
Startup Operation
Temperature Unit
1, 2, 3...
Operation Mode Change
14
Pin 5 is used to set the startup operation.
Startup operation
Pin 5
The factory setting is for stop operation control (pin 5 OFF).
If the power is turned OFF during manual operation and pin 5 is set to ON (con-
tinuous operation), manual operation will automatically begin when the power is
turned ON again. The output value will be 0%.
Pin 6 is used to set the unit for measuring temperature.
Temperature unit
Pin 6
The factory setting is for degrees Celsius (pin 6 OFF).
When the temperature unit is changed, the temperature data does not automati-
cally change, so make sure to reset the temperature using the following proce-
dure.
1. Initialize the setting data.
2. Recalculate the data according to the following conversion formula and re-
set the control data within the setting range.
(value in _F) = 1.8 x (value in _C) + 32
3. Store the settings in memory.
Pins 3, 4, 5, and 8 are used to change the operation mode.
E5ZE operation mode
Pins 3, 4, 5, and 8
The factory setting is for Control Mode (pins 3, 4, 5, and 8 all OFF).
Control Mode:
Hardware Test Mode:
Refer to Appendix E for details on how to use Hardware Test Mode. Outputs can
be turned ON and OFF in Hardware Test Mode regardless of the process value.
Stop operation control
_C
Control mode
Use for normal temperature control.
Use for testing Peripheral Devices and wiring.
Section 2-3
Continue status at
power OFF
_F
Hardware test mode