Operation Instructions For Each Sensor (Fiber Amplifier Unit) - Omron E3X-DRT21-S User Manual

Sensor Setting/Monitoring/Operating Functions from Configurator
Operation Instructions for Each Sensor (Fiber Amplifier
Unit)
1. Switch the Configurator to online (select [Network] - [Connection]).
2. Select and double-click the applicable communication unit.
3. DIn the [Edit Device Parameters] dialog box, click the [Teaching...] button on the right of
the registered fiber amplifier unit type.
4. DIn the [Teaching of Sensor #xx] dialog box, configure the following settings.
• Set maximum sensitivity
• Teaching without a reflective workpiece
• Teaching without a through-beam workpiece
• Teaching with the workpiece or without a workpiece
• Start auto teaching
• Stop auto teaching
• Position teaching
• Power tuning settings
• Hyper teaching
• Zero reset
• Cancel zero reset
• Stop projection lighting
• Start projection lighting
• Reset counter
In the bottom right, the sensor's ON/OFF, the detection level, the detection level when
ON, and the detection level when OFF are shown.
Section 3
E3X-DRT21-S
81
User's Manual