Usb/Gpib/Uart/Lan Settings; Usb Setting; Gp-Ib Address Setting; Uart Communication Setting - TEXIO PSW-A Series Instruction Manual

3.3. USB/GPIB/UART/LAN Settings

3.3.1.

USB setting

Displays the usage status of the front and rear panel USB A ports and
configures the rear panel USB.
Front Panel USB State
Displays the front panel
USB-A port state.
(Only confirmation)
Rear Panel USB State
Displays the rear panel
USB-B port state.
(Only for confirmation)
Rear Panel USB Mode
Sets the rear panel USB
mode.
Note
3.3.2.

GP-IB Address setting

Sets the GP-IB address.
Item
GP-IB Address
3.3.3.

UART communication setting

Sets the UART (RS-232C) communication settings.
Settings can be made when GUR-001B is connected to this product.
UART Baud Rate
Set baud rate
(Unit: bps)
Setting Setting Range
F-20
Setting Setting Range
F-21
Setting Setting Range
F-22
When there is an interference source in the operating
environment, setting "F-22: 3" and lower the data transfer
rate, can reduce the influence of the interference source.
Setting Setting Range
F-23
Setting Setting Range
F-71
0: Absent
1: USB memory exists
0: Not used
2: USB-CDC
3: GPIB-USB adapter
5: RS-232C adapter
0: Disable
1: USB Host
2: USB CDC (Auto detect speed)
3: USB CDC (Full speed)
0 ~ 30
0: 1200
1: 2400
2: 4800
70