Reset To Factory Default Settings; Verifying Firmware Version And System Information - TEXIO PSW-A Series Instruction Manual

2.1.11. Reset to Factory Default Settings

This product can be reset to factory default settings. For factory default
settings, see page 136.
steps Step instructions
1 Press the Function key. The Function
key will light up.
2 The display should show F-01 on the top
and the configuration setting for F-01 on
the bottom.
3 Rotate the Voltage knob to change the F
setting to F-88 (Factory Set Value).
4 Use the Current knob to set the F-88
setting to 1 (Return to factory settings).
5 Press the voltage knob to determine the
setting.
When the settings are confirmed, "ConF"
will be displayed.
6 Press the Function key again to exit. The
function key light will turn off.

2.1.12. Verifying firmware version and system information

steps Step instructions
1 Press the Function key. The Function
key will light up.
2 The display should show F-01 on the top
and the configuration setting for F-01 on
the bottom.
38
Voltage