Front Cover; Configuration Settings; Setting Configuration Settings - TEXIO PSW Series Programming Manual

1. Configuration Settings

1.1 Setting Configuration Settings

Background
Note
Steps. 1.
2.
3.
4.
5.
Exit
The normal configuration settings (F-01~F-61, F-88,
F-89) are used to configure or view system settings.
Use the following operation steps when configuring the
interface settings used in the Remote Control chapter.
Ensure the load is not connected.
Ensure the output is off.
Configuration settings F-90~F-95 cannot be edited in
the Normal Function Settings. See the user manual for
details.
The F-89 settings can only be viewed, not set.
Press the Function key. The function key
will light up.
The display will show F-01 on the
top and the configuration setting for
F-01 on the bottom.
Rotate the voltage knob to change the F
setting.
Range F-00~ F-61, F-88, F-89
Use the current knob to set the parameter
for the chosen F setting.
Press the Voltage knob
to save the
configuration setting.
Conf will be displayed
when successful.
Press the Function key again to exit the
configuration settings.
The function key light will turn off.
1
Function
Voltage
Current
Voltage
Function