Attaching Flat Cable Connectors - Omron DEVICENET Operation Manual

Wiring Methods
1,2,3...
Note
1. Cut the cable.
Cut the cable perpendicular to the length.
To prevent short-circuits, cut the cable with a sharp tool, such as wire cut-
ters, and make sure that no whiskers are left on the wires.
2. Attach the cable.
Align the indications on the cable identification label with the cable colors
and insert the cable. The cover is translucent, so it is possible to confirm
that the cable has been inserted all the way in.
3. Pressure-weld the connector.
Use the DWT-A01 Pliers to pressure-weld the connectors.
1) As shown in the following diagram, align the center of the connector cov-
er (see arrows) with the center of the pressure-welding block on the Pli-
ers.
Pliers
2) Squeeze firmly on the Pliers until the lock on the connector clicks into
place.
1. Do not pressure-weld the connector cover at the edges.
2. Do not pressure-weld the connector cover at the back of the pressure-
welding block.
3. Set the connector in the correct orientation.
OK
NG
Confirm that the cable has been
inserted up to this position.
Connector cover
NG
NG
Section 2-4
67