Tuning Screens - Omron CXONE-ALC-V4 - 10-2010 Operation Manual

Segment Program 3 (Block Model 158)

6-19-2 Tuning Screens

Button
Stop block operation MT_ST
command
(ITEM 000)
Disable reference S5
input
(ITEM 020)
AT command/AT AT(026)
executing
120
1
3
4
1: Status Display
These button are used to switch between the status of the Stop block opera-
tion command (tag ITEM MT_ST (ITEM 000)) and Disable Reference Input
Switch (tag ITEM S5 (ITEM 020)). These buttons are built as alternate ON/
OFF Buttons using Simple Rectangles (Type 2), according to the information
in the following table.
Tag ITEM OFF color
Gray
Gray
Gray
The read address is set in the display address and the write address is set in
write address 1.
2: Alarm Setting/Parameters
Segment Program 3 does not provide alarm settings or parameter settings.
3: Realtime Trend Graph
Tag ITEM X1 (ITEM 007) and tag ITEM Y1 (ITEM 008) are displayed as
graphs. Each tag ITEM is drawn using the following graph lines.
Tag ITEM Color
Green −1500
X1
Yellow −1500
Y1
2
ON color OFF label
Yellow Operating
Yellow Ref. ON
Yellow AT
Minimum Maximum
value value
11500
11500
Section 6-19
5 6
ON label Write confirmation
message
Suspended Yes
"OK?"
Ref. OFF Yes
"OK?"
AT Yes
"Executing or stop-
ping the AT com-
mand will change the
MV. OK?"
Line type Marker Step display
Solid line None Not used.
Solid line None Not used.