Omron CXONE-ALC-V4 - 10-2010 Operation Manual page 85

Section 6-7
Segment Program 2 (Block Model 157)
■ Time Width-Output Value Setting Screen
1 2 3 4 5 6 7
1: Time Width, Output Value, and Unit
The time width, output value, and unit are set for each step.
The unit is selected from a drop-down list. The time width and output value
are input from the ten-key pad. The time width and output value field will auto-
matically open for ten-key pad when clicked.
2: Read Button
This button reads the setting and current values for reference input values,
output values, and steps for the Segment Program 2 function blocks set in the
Loop Control Board/Unit.
Any settings made on the screen will be discarded if the Read Button is
clicked before clicking the Write Button.
3: Write Button
The button writes the settings made on the screen to the Loop Control Board/
Unit.
Note Be sure to check the affect on the controlled system of any changes to be
made before actually writing them to the Loop Control Board/Unit.
4: Backup Button
This button backs up data during operation. This is performed to back up
changed settings to the flash memory in the Loop Control Board.
The backup during operation function backs up the function blocks in the RAM
in the Loop Control Board to the flash memory in the Loop Control Board. A
CS1W-LCB01/05 Loop Control Board Ver. 1.5 or later or a CS1D-CPU@@P
Process-control CPU Unit is required to back up data during operation.
5: Scale Buttons
These buttons are used to change the scale of the output value axis (i.e.,
Scale on the Time Width-Output Value Setting Screen). Either a 0 to 100.0
(Scale 1) or a -300.0 to 300.0 (Scale 2) can be selected.
69