On/Off Valve Manipulator (Block Model 221) - Omron CXONE-ALC-V4 - 10-2010 Operation Manual

ON/OFF Valve Manipulator (Block Model 221)

6-13 ON/OFF Valve Manipulator (Block Model 221)

86
The following macro is set as a Touch OFF Timing macro, and when touched,
the fixed value 0 is written to the write address of tag ITEM S1 (ITEM 010).
$B32766=0;
WRITECMEM([S1],$B32766,1);
9: MV Display, MV Change Button, and MV Index Position
The Counter face plate does not provide an MV display, MV Change Button,
or MV index position.
10: Tuning Screen Button
The Counter face plate does not provide a Tuning Screen Button.
The following diagram shows a Counter face plate built using the Face Plate
Auto-Builder for NS in a 640×480 screen resolution.
The whole face is built using 458×142 dots.
The display and operation of each object in the face plate is the same as the
version for 800×600 screen resolution.
This section describes only the differences between the ON/OFF Valve
Manipulator Block and Basic PID Block (Block Model 011). For details on the
areas not covered here, refer to 6-1 Basic PID (Block Model 011).
Section 6-13