Cp/Cpm1A-Series Expansion I/O Unit I/O Specifications - Omron CP1L CPU UNIT - 03-2009 Operation Manual

Specifications
Note
PWM Outputs (CIO 100.01 and CIO 100.03)
2-2-4

CP/CPM1A-series Expansion I/O Unit I/O Specifications

Input Specifications (CP1W-40EDR/40EDT/40EDT1/20EDR1/20EDT/20EDT1/8ED and
CPM1A-40EDR/40EDT/20EDR1/20EDT/20EDT1/8ED)
Note
Output Specifications
Relay Outputs (CP1W-40EDR/32ER/20EDR1/16ER/8ER and CPM1A-40EDR/20EDR1/16ER/8ER)
(1) The load for the above values is assumed to be the resistance load, and
does not take into account the impedance for the connecting cable to the
load.
(2) Due to distortions in pulse waveforms resulting from connecting cable im-
pedance, the pulse widths in actual operation may be smaller than the
values shown above.
Item
Max. switching capacity
Max. output frequency
PWM output accuracy
Output waveform
Item
Input voltage
Input impedance
Input current
ON voltage
OFF voltage
ON delay
OFF delay
Circuit configuration
(1) The response time is the hardware delay value. The delay set in the PLC
Setup (0 to 32 ms, default: 8 ms) must be added to this value. For the
CP1W-40EDR/EDT/EDT1 and CPM1A-40EDR/EDT/EDT1, a fixed value
of 16 ms must be added.
(2) Do not apply voltage in excess of the rated voltage to the input terminal.
Item
Max. switching capacity
Min. switching capacity
Specification
30 mA/4.75 to 26.4 VDC
1 kHz
For ON duty +1%, −0%:10 kHz output
For ON duty +5%, −0%: 0 to 32.8 kHz output
OFF
ON
t
ON
T
Specification
+10%
24 VDC /
−15%
4.7 kΩ
5 mA typical
14.4 VDC min.
5.0 VDC max.
1 ms max. (See note 1.)
1 ms max. (See note 1.)
IN
Input LED
4.7 kΩ
IN
CO M
2 A, 250 VAC (cosφ = 1),
2 A, 24 VDC (4 A/common)
5 VDC, 10 mA
Section 2-2
t
ON
× 100%
ON duty =
T
Internal
circuits
Specification
69