Din Track And Accessories - Omron CJ2 CPU UNIT User Manual

5 Installation
4
Install a DIN Track End Plate on each end of the PLC. To install an End Plate, hook the bottom
on the bottom of the track, rotate the Plate to hook the top of the Plate on the top of the track,
and then tighten the screw to lock the Plate in place.
End Plates

DIN Track and Accessories

Use the DIN Track and DIN Track End Plates shown below. Secure each DIN Track inside a control
panel with at least three screws.
• DIN Track
Model numbers: PFP-50N (50 cm), PFP-100N (100 cm), PFP-100N2 (100 cm)
Secure the DIN Track to the control panel using M4 screws separated by 210 mm (6 holes) or less and
using at least 3 screws. The tightening torque is 1.2 N·m.
PFP-100N2 DIN Track
4.5
25
15
10
PFP-100N/50N DIN Track
4.5
15 25
10
• PFP-M DIN Track End Plates (2 required)
5-16
Twenty-eight, 25 × 4.5 oblong holes
25
25 25 15
10
1000
25 25 25
15 (5)*
10
1000 (500)*
2
1
16
30 0.3
27 24 29.2
1 1.5
7.3 0.15
35 0.3 27 0.15
1
* PFP-50N dimensions are
given in parentheses.
CJ2 CPU Unit Hardware User's Manual