Using Pulse Outputs With Variable Duty Ratio - Omron 3G3MV-P10CDT-E User Manual

Communication, Counter and Pulse

4-4-2 Using Pulse Outputs With Variable Duty Ratio

Pulse Outputs With Variable Duty Ratio
PLC Setup
52
Select the pulse output number.
Wire the outputs.
Create a ladder diagram program.
Make the following settings in the PLC Setup.
Word
DM 6642 08 to 15
Synchronized pulse control cannot be used simultaneously.
The settings will go into effect when the mode is changed (from PROGRAM
to MONITOR/RUN) or when the power supply is turned ON to the PLC.
Pulse output number 0 or 1
Output numbers: 01000 and 010001
PWM(---): For setting the frequency and duty ratio.
INI(61): For stopping outputs.
PRV(62): For reading the pulse output status.
Bits
High-speed
counter
setting
Function
00: Do not use.
01: Use as high-speed counter
02: Use as synchronized pulse
control (10 to 500 Hz).
03: Use as synchronized pulse
control (20 Hz to 1 kHz).
04: Use as synchronized pulse
control (300 Hz to 20 kHz).
SECTION 4
Setting
Either
00 or
01