Omron 3G3MV-P10CDT-E User Manual page 32

Unit Components and Specifications
Item
Allocated to
Inverter
PLC Setup
Item
Interrupt External
processing interrupts
Scheduled
interrupts
Pulse outputs
Pulse synchronous control
Pulse catch inputs
Analog volume
Input time constant
(ON response time =
OFF response time)
Clock function
Communication function
Power-interruption hold function
Memory backup
Self-diagnostic function
Program check
Connected CX-Programmer
tools
Programming
Console
SSS
Sysdrive
Configurator
19 words (DM 2022 to DM 2040)
56 words (DM 6599 to DM 6655)
2 bits (Used in common for input interrupt counter mode and high-
speed inputs.)
1 bit (Scheduled interrupts or one-shot interrupts)
2 bits (without acceleration/deceleration; 10 Hz to 10 kHz each; without
directional control).
Or 1 bit (with trapezoidal acceleration/deceleration; 10 Hz to 10 kHz
each; with directional control).
Or 2 bits (Variable duty ratio output).
1 bit
A high-speed counter can be combined with pulse output, and the
input pulse frequency from the high-speed counter can be multiplied by
a fixed factor for pulse output.
2 bits
Minimum pulse input: 50 µs max.
Used in common by input interrupts and input interrupt counter mode.
None
Only all inputs can be set.
(1 ms / 2 ms / 3 ms / 5 ms / 10 ms / 20 ms / 40 ms / 80 ms)
Yes
Port 1 = Peripheral and RS-422
Host Link, Peripheral bus, No-protocol, Programming
Console
Port 2 = RS-232C port:
Host Link, no-protocol, 1:1 PLC Link, 1:1 NT Link
Holds the contents of HR, AR, CNT, and DM Areas.
Non-volatile memory, User program, DM (Read only), PLC Setup
Fixed internal lithium battery (5 years, not replaceable by the user) or
capacitor
DM (Read/Write), HR, SR and CNT Areas
CPU errors, memory errors, communications errors, setting errors,
battery errors
No END instruction, program errors (regularly checked during
operation)
After Version 2.1
C200H-PRO27, CQM1-PRO01
PC98 & PC/AT (SYSMAC Support Software, All version)
After version 2
Specifications
Specifications
SECTION 2
19