Icom ID-RP2010V Settings Manual page 9

1
USING THE UTILITY FOR ID-RP3
Programming the repeater
D Setting a password for receiving an
Emergency stop signal
Enter the password to accept receiving an Emergency
Stop signal. The repeater stops operating or resumes
operation when it received a signal with a password
that matches the password set in this window.
1. Confirm the repeater is turned ON.
L If multiple repeaters are connected, confirm all of
them are turned ON.
2. Open the utility.
3. Select "Password Setting" in the <Tool> menu.
• The "Password Setting" window is displayed.
NOTE:
• This window cannot be closed by clicking <OK> without entering anything.
• Rewrite the password displayed on "Password" text box to change the password.
• The password will be "PASSWORD" when you reset the repeater to default.
• The password will not be saved to a setting file (icf).
• The following are required to access the repeater through a LAN port:
- Setting a password
- "Use for Remote access via the LAN port" is checked.
4. Select the target repeaterʼs ID in "Setting Target."
L If multiple repeaters are connected, "Set to all" is
selected in default.
L When setting a different password for each
repeaters, select the target repeater ID and repeat
Step 4 and 5.
5. Enter the password with 8 characters.
6. Click <OK> to close the window.
7