Icom ID-RP2010V Settings Manual page 14

3
DIGITAL REPEATER SETTING
Utility for ID-RP3 settings (Common)
The settings shown below are the minimum required
to use the Digital Repeater function. See the Utility for
ID-RP3 HELP for more details for other setting items.
D RX Frequency/TX Frequency
Enter the repeaterʼs receive/transmission frequency.
×
L " " is displayed when frequencies are set to default.
L Confirm the entered frequency follows your local
regulations.
DV mode:
DD mode (For only the ID-RP1200VD):
Confirm the [DV/DD] switch on the repeater's rear panel is
set to "DD."
D Mode
Select the repeaterʼs operating mode.
L Not selectable when configuring the DD mode
ID-RP1200VD.
D Call Sign
Enter the repeater call sign used for operation.
L An Emergency Stop command provided through LAN is
usable by setting the call sign.
D Squelch Level
Enter the squelch level at which the squelch just
opens and the repeater starts operating.
D Selecting the output power
Select the Output power using the [H/L] switch on the
repeaterʼs front panel.
12